|
Craft Courses / Tuition - see bottom of
page (free advertising)
For craft projects, ideas and templates
please click here
A sophisticated adaptation of stenciling
techniques, screen printing is used
by artists and designers to transfer simple and complex images onto paper,
fabric and other surfaces. Designs can feature just one or a number of fabrics.
Origins of screen printing
Stenciling uses a design cut out from paper or cardboard. The stencil is
then temporarily fixed to the surface or fabric while the design is filled with
colour.
Artists found that stencils limited design possibilities because the image
can only use blocks of colour while floating parts - such as the centre of an
'o' - cannot be completely cut out. The ancient Chinese, and later, European
stencillers, tried to get round this problem by using fine hairs as tabs. The
hairs held the floating parts in place, without blocking the ink or paint when
it was brushed over the surface.
This idea gradually developed until by the middle of the 19th century
stencils were being held in place by silk screens - pieces of silk stretched
over a frame. The mesh of the silk was fine enough to allow paint to be pushed
through it.
At first the use of silk screens was limited to the production of cheap
advertisements and wrapping paper. As the process became more popular it was
used to print wallpapers and in 1915, the development of photographic silk
screen stencils revolutionized the fabric painting industry.
Nowadays, synthetic materials are much more widely used than the original
silk mesh, offering a better range of effects and enlarging the uses of screen
printing techniques. In the 1990's artists such as Paolozzi, Rauschenberg and
Warhol adopted screen printing with enthusiasm, using it on large scale canvases
and photo stencil collage images. Their colourful, bold pictures were an
important influence in the modern art world - screen printing is nowadays widely
used by artists.
 Basic techniques
The silk screen is a fine meshed fabric stretched over a wooden frame. The
mesh can be made of a wide range of materials, including synthetics such as
terylene.
The edges of the mesh are masked with tape to prevent ink seeping out.
The squeegee consists of a strip of rubber attached to a piece of wood. It
pushes the ink across the screen, forcing it through areas of the mesh not
blocked by the stencil. The squeegee must be wider than the print, but narrower
than the frame.
Silk screen inks have the consistency of thick cream to prevent them running
across the screen and seeping under the stencil. They are fairly slow drying, to
prevent the mesh becoming clogged up.
The type of ink used depends on the stencil: for example, oil based rather
than water based inks are used to block out glues that dissolve in water. There
are also specialized inks for printing on textiles, wood, glass, metal and even
ceramics.
The stencil is painted or stuck onto the screen using a number of methods and
materials.
Cut paper - the stencil is cut from paper either as a positive or a negative
print. The stencil is then placed on the receiving paper with the screen on top.
When the squeegee forces ink through the mesh, the stencil sticks to it. The cut
out stencil can be used about 50 times before it disintegrates. After printing,
the screen is washed with water.
Liquid block out stencil - a substance such as lacquer, shellac or glue is
painted onto the screen to prevent the ink passing through. A fine mesh gives
the screen print sharp edges, a loose mesh gives fuzzy edges.
Tusche-glue stencil - this technique is based on the principal that oil and
water don't mix. The prints must be made with oil based inks. The design is
painted on the screen with tusche which resists water. A water based glue is
then painted over the whole screen before the tusche is cleaned off with a
solvent. The ink is then able to pass through the mesh where the tusche and glue
has been removed.
There are two main printing techniques. The simpler method, one colour
printing, uses one stencil while multicolour printing uses two or more stencils.
One colour printing - ink is spread along the masked edge and then pulled
over the screen using the squeegee. If two or more colours are spread along the
masked edge, they will merge sideways into each other as the ink is spread over
the screen giving a rainbow effect.
Multicolour printing - enables the printer to use different colours on
different parts of the print. A seperate stencil is made for each colour. To
avoid double images or blurred colours, registration marks are used so that each
stencil and print is placed in exactly the same position as the originals.
Some chemicals and solvents used in screen printing are inflammable or give
off dangerous vapours. Please take adequate precautions.
Courses
If you offer screen printing courses / evening classes / demonstrations -
please contact us to advertise your details here.
To learn proper screen printing techniques the best starting point is to
contact polytechnics / art schools / workshops /colleges to see if they have any organized
courses.
If you are inspired to become
a professional screen printer, you could also
consider a trade apprenticeship.
back
to top
back to
craft topics
Why not visit our craft forum to
gain tips, advice and chat to fellow crafters, click
here
Attention Craft
Workers!
We want to hear all
about your craft, the history and skill involved to make your craft
from start to finish. Photos of you at work would be great and step by
step instructions would be helpful. Any advice that you could give
people wishing to start up in the craft business. And if any courses,
training, talks, etc that you offer.
To
add to this page please contact us - to link to this page please copy
and paste the url from the address bar.
Crafters Wanted!
Whether your craft is a hobby, part time or full time job then this is
the place for you. Click here
for advertising details or if you require advice on how to start up
with crafts then click
here |
Crafts
Crafts
Crafts
Crafts
Crafts
Screenprinting
Craft Topics
Introduction